Quick Answer: How To Clean A Motorcycle Engine?

Can you power wash a motorcycle engine?

If your bike is really dirty, you can use a pressure washer to get the worst of the grime off. But, be careful. Motorcycles are water resistant, not waterproof. Use high pressure water for the wheel rims and under the fenders, but be careful around the engine, where the electronics are.

How do you clean a greasy motorcycle engine?

  1. Step 1 – Blow Out Dirt and Dust.
  2. Step 2 – Cover Electronic Parts.
  3. Step 3- Spray on Degreasing Agent.
  4. Step 4 – First Rinse.
  5. Step 5 – Apply More Degreaser.
  6. Step 6 – Scrub Away Dirt and Grime.
  7. Step 7 – Rinse and Dry the Engine.
  8. Step 8 – Treat Rubber Parts.

What should you not wash a motorcycle with?

What Not to Do

  1. Don’t use the same detergent you use on your car. Get a motorcycle-specific cleaner.
  2. Don’t wash your bike when it’s hot. Only wash it when the engine is cool.
  3. Don’t wash your bike in direct sunlight.
  4. Don’t use a high-pressure hose.

How often should you clean your motorcycle?

As a general rule of thumb, it’s important to wash your motorcycle at least every two weeks. Obsessives will do it every week, or sometimes more frequently. Additionally, irregular dirt such as road salt and bug guts require immediate attention to prevent paint or metal damage.

You might be interested:  Quick Answer: How To Get Check Engine Code?

Can you degrease a hot engine?

Talk about an effortless step! Start your car and let it run 5-10 minutes. This loosens the accumulated grease and oil and other stuff stuck on the engine. In addition, a warm engine works well with degreaser products.

How do you clean and degrease an engine?

Spray the degreaser over the entire engine and let it soak for the recommended time. Apply additional coats (if needed) to really greasy areas. Then rinse with a water mist, using as little water as possible. An engine degreaser works best when the grease is warm and soft.

Is gunk a good degreaser?

Gunk Engine Degreaser



After leaving the Gunk on our test oil catcher for 10 minutes, it loosened plenty of grease, although lots of work with the brush and thorough rinsing was required to wash off the white residue created. The competitive price kept it in the running, making it a worthy option.

Leave a Reply

Your email address will not be published. Required fields are marked *