How To Remove Omc Outdrive From Engine?

Removal of the OMC Cobra Outdrive

  1. Continue to insert the lifting eye into the top gear housing until the thread engagement is complete.
  2. The trim/tilt pivot rod’s elastic locknut A and flat washer B should be removed and retained.
  3. Lightly tap the trim/tilt pivot rod out of the trim/tilt cylinder with a gentle hammer to free it.

How do I remove the OMC Stringer complete outdrive?

The removal of the OMC Stringer Complete Outdrive is required. 1. To remove the shift cable retainer from the intermediate, tilt the vertical drive until it is exposed. Then remove the retainer screw and lockwasher. 2. Tilt the vertical drive down to the position illustrated in Figure 7-2, immediately before the locating pins are inserted into their respective seats. 3. 3.

How do you pull the engine out of the drive?

The driveshaft must be removed from the coupler in order for the engine to be removed.It may be feasible to pull the engine forward and away from the driveshaft, but it is far simpler and safer to just pull the drive off, which takes about 15 minutes.Pulling the engine and removing the outdrive?

Yes, as previously said, withdraw the drive.This machine is equipped with a driveshaft that connects to a coupler located on the ‘bellhousing’.

How do you remove the drive shaft from a Merc Alpha?

A Merc Alpha is designated by the shifter in forward. The OMC Cobra should be left in the NEUTRAL position. In order to remove the drive, first remove the bolts holding the trim rams to the crossbar and slide them off, then remove the 6 nuts holding the drive and rock them off, being cautious as the drive weighs around 90 lbs.

You might be interested:  What Engine Is Titanfall 2 Using?

How easy is it to remove the drive?

In order to remove the drive, first remove the bolts holding the trim rams to the crossbar and slide them off, then remove the 6 nuts holding the drive and rock them off, being cautious as the drive weighs around 90 lbs. I created a stand to make it more convenient. The driveshaft must be removed from the coupler in order for the engine to be removed.

Leave a Reply

Your email address will not be published. Required fields are marked *